Bridging - Comtrend Corporation CT-5361T User Manual

4.2.4

Bridging

STEP 4: To enable bridge service, tick the checkbox
STEP 5: Click Next to display the following screen.
Enter the IP address and subnet mask for the LAN interface. These settings are
used to manage the CT-5361T. In bridge mode, there is no WAN IP address and
therefore no remote access to the router for technical support or other purposes.
STEP 6: Click Next to proceed to the Wireless Setup screen. To enable wireless,
tick the checkbox
change the SSID (Service Set Identifier) at this point.
and click Next. If you wish to do so, you may also
33
and enter a service name.