Table of Contents
Advertisement
To configure a secondary IP address for the LAN port, click the checkbox
STEP 7: Click Next to proceed to the Wireless Setup screen. To enable wireless,
tick the checkbox
change the SSID (Service Set Identifier) at this point.
STEP 8: Click Next to display the configuration summary. Click Save/Reboot if
the settings are correct. Click Back if you wish to modify the settings.
After clicking Save/Reboot, the router will save the configuration to the flash
memory and reboot. The Web UI will not respond until the system is brought up
again. After the system is up, the Web UI will refresh to the Device Info screen
automatically. The CT-5361T is ready for operation when the front panel LED
indicators display as described in section
and click Next. If you wish to do so, you may also
2.4 LED
32
Indicators.
shown.
Hide quick links:
Advertisement
Table of Contents
