Initial Printer Setup - Xerox WorkCentre 7220 User Manual

Installation and Setup
3. Close the front door.
4. Turn on the secondary power switch.
Note: When the optional Office Finisher LX is installed, the secondary power switch is behind a clear
plastic door.
Secondary Power Switch
To connect a cable or move the printer, turn off both power switches.
To turn off the printer:
1. Ensure that there are no jobs in the queue.
2. Turn off the secondary power switch, then wait 10 seconds after the touch screen goes dark before
proceeding.
Note: When the optional Office Finisher LX is installed, the secondary power switch is behind a clear
plastic door.
3. Open the front door.
4. Turn off the main power switch.
5. Close the front door.

Initial Printer Setup

Make sure that the printer is set up before installing the printer software. Setup includes enabling the
optional features and assigning an IP address for the Ethernet network connection. If the printer has not
been previously turned on and configured, see the System Administrator Guide at
www.xerox.com/office/WC7220_WC7225docs.
40 WorkCentre 7220/7225 Multifunction Printer
User Guide
Secondary Power Switch with Office Finisher LX