NetComm 3G22WV User Manual page 32

 Click Enable on the RIP Page
Select RIP version

 Click the Save button.
NAT
The NAT page is used to configure the Network Address Translation rules currently in use on the router. The router is in NAT mode
by default. The NAT configuration settings are also known as Port Forwarding rules.
This is only needed if you need to map inbound requests to a specific port on the WAN IP address to a device connected on the
Ethernet interface, e.g. a web camera.
How to configure Port Forwarding
OPTION
Item no
Protocol
Source IP Address
Incoming Port Range
Destination IP Address
Destination Port Range
1. Enter the IP Mapping configuration information as appropriate.
2. Click Save
Please note: If the "Incoming Port Range" specifies a single port (as above) then the destination port can be set to any port.
If the "Incoming Port Range" specifies a range of port numbers then the "Destination Port Range" MUST be the same as the
"Incoming Port Range".
To delete a port forwarding rule, click on the corresponding "Delete Entry" link from the list of IP Mappings.
www.netcommwireless.com
Figure 32 - NAT Settings
Number to identify the port mapping. 1 to as many as needed.
Specify the protocol to use for the port mapping. TCP, UDP, All protocols.
Specifies either a "Friendly" IP address that is allowed to access the router or a wildcard IP address of 0.0.0.0 that
allows all IP addresses to access the router.
Specify the external port(s) to listen to.
Local Area Network Address of device to forward inbound requests to.
Local Area Network Port(s) to forward connections to.
Table 21 - NAT Configuration Items
DEFINITION
3G22WV – 3G WiFi Router with Voice User Guide
32