Table of Contents
Advertisement
The cursor displays a fade-in icon when it is ready to add a fade-in:
2.
Drag the vibrato segment to the right for the length of the fade-in that you want to add.
Editing Time
To edit timing with V-Vocal, the Time button in the edit mode section must be enabled.
To Edit Time
1.
Make sure the Time button is enabled.
2.
Move the Arrow tool near the vertical center of the graph until the cursor changes to the double
arrow, and click at each point where you want to preserve the original timing. A vertical green line
appears at each point that you click.
3.
Now add new green lines between the existing ones.
4.
Drag the new lines to the left or right to compress or expand each region.
Tips:
•
Hold down the Ctrl key while you move lines to move all the following lines by an equal amount.
•
To erase lines, drag a region with the eraser. Timing reverts to its original condition in the areas
where you erase lines.
Editing Formants
A rough definition of formants is that they are vowel sounds. To edit formants with V-Vocal, the
Formant button in the edit mode section must be enabled.
Here's a picture of the V-Vocal interface in formant mode:
The red line in the graph is the formant line. The red dots on the line are nodes.
To Shift the Formant of a Region
1.
Use the Arrow tool to select the region you want to shift.
2.
Drag the red line in the region up or down.
.
397
Advertisement
Table of Contents
Troubleshooting
