CAKEWALK SONAR User Manual page 120

:
Velocity trim
Input
Output
Ch (channel)
Bank
Patch
Time+
Key+
Chorus
Reverb
Snap to Scale scale
type
Snap to Scale root note
Snap to Scale on/off
To Change a Track Name
1. Double-click on the current track name.
2. Enter the new track name.
3. Click Enter.
The default track names (Track 1, Track 2, etc.) are not actually names, but placeholders until you
name a track. If you reorder the tracks these placeholders change.
You can rearrange and resize the panes in the Track view as shown in the following table:
To do this...
Change the width of the Track pane and
Bus pane
Change the height of the Mains/Buses pane
You can customize which tracks are displayed or not displayed, and enlarge or maximize individual
tracks while other tracks remain minimized. You can also manually set the exact size of a track's
display. The following table shows how to customize the appearance of tracks in the Track pane:
To do this...
120
The change in velocity (volume) that will be applied to notes in this
track on playback; ranges from –127 to +127
The input source for the track, used in recording
The output device through which the track is played
The MIDI channel through which the notes will be played
The set of patch names available for the track
The instrument sound that will be used for playback.
An offset applied to the start time of the events in the track
The number of steps by which the notes in the track are transposed on
playback (e.g., 12 to transpose up one octave)
Adds MIDI chorus effect to the track
Adds MIDI reverb effect to the track
Displays current scale for Snap to Scale feature
Displays root note of current Snap to Scale scale
Turns Snap to Scale feature on or off
Do this...
Drag the divider that separates the Track pane
from the Clips panes to the left or right
Drag the divider that separates the Track and Clip
panes from the Bus pane up or down
Do this...