Table of Contents
Advertisement
:
196
Note that if you copy or move clips to new, empty tracks, you don't have to worry
about these settings. In this case, the track properties that go with the clips are
automatically applied to the new track.
When you use drag-and-drop editing:
•
You can set the above options every time you perform an edit, or you can set
them once and have the same settings carry over automatically. Check or
uncheck the Ask This Every Time box in the Drag and Drop Options dialog
to indicate your preference. Open the Drag and Drop Options dialog by right-
clicking in the Clips pane and choosing Drag and Drop Options from the
popup menu.
•
If you drag to the edge of the Clips pane, it will scroll automatically in the
direction you drag.
•
If you change your mind while dragging clips, press the Escape key to cancel
the operation.
SONAR also lets you move and copy clips between projects.
To Move Clips Using Drag and Drop
1.
Select the clips you want to move.
2.
If you want to move the clips by an exact amount of time, enable the Snap
Grid (see "To Change the Snap Options" on page 202).
3.
Position the mouse over one of the selected clips.
4.
Press and hold down the left mouse button. A rectangle is displayed around
the selected clips.
5.
Drag the clips to their new location, and release the mouse button.
6.
If necessary, choose the options you want from the Drag and Drop Options
dialog box (use Options-Global and open the Editing tab, or right-click in
the Clips Pane and select Drag & Drop Options from the menu that
appears), and click OK.
Advertisement
Table of Contents
Troubleshooting
