Identity
MD5 Password
802.1X Certificate
802.1X Client
Certificate
PORT FORWORDING (UCM6102 ONLY)
The UCM6102 network interface supports router functions which provides users the ability to do port
forwarding. Please see port forwarding settings in the table below.
WAN Port
LAN IP
LAN Port
Protocol Type
FIREWALL
The UCM61xx provides users firewall configurations to prevent certain malicious attack to the UCM61xx
system. Users could configure to allow, restrict or reject specific traffic through the device for security and
bandwidth purpose. To configure firewall settings in UCM61xx, go to Web GUI->Settings->Firewall page.
STATIC DEFENSE
Under Web GUI->Settings->Firewall->Static Defense page, users will see the following information:
•
Current service information with port, process and type
•
Typical firewall settings
•
Custom firewall settings
The following table shows a sample current service status running on UCM61xx.
Firmware Version 1.0.1.22
Enter 802.1X mode identity information.
Enter 802.1X mode MD5 password information.
Select 802.1X certificate from local PC and then upload.
Select 802.1X client certificate from local PC and then upload.
Table 11: UCM6102 Network Settings->Port Forwarding
Specify the WAN port number. Up to 8 ports can be configured.
Specify the LAN IP address.
Specify the LAN port number.
Select protocol type "UDP Only", "TCP Only" or "TCP/UDP" for the forwarding in
the selected port. The default setting is "UDP Only".
UCM6102/6104/6108/6116 USER MANUAL
Page 30 of 138