Connect Your Ucm61Xx; Connect The Ucm6102; Figure 1: Ucm6102 Front View; Figure 2: Ucm6102 Back View - Grandstream Networks UCM6102 User Manual

CONNECT YOUR UCM61XX

CONNECT THE UCM6102

To set up the UCM6102, follow the steps below:
1. Connect one end of an RJ-45 Ethernet cable into the WAN port of the UCM6102;
2. Connect the other end of the Ethernet cable into the uplink port of an Ethernet switch/hub;
3. Connect the 12V DC power adapter into the 12V DC power jack on the back of the UCM6102. Insert
the main plug of the power adapter into a surge-protected power outlet;
4. Wait for the UCM6102 to boot up. The LCD in the front will show the device hardware information
when the boot process is done;
5. Once the UCM6102 is successfully connected to network, the LED indicator for WAN in the front will
be in solid green and the LCD shows up the IP address;
6. (Optional) Connect PSTN lines from the wall jack to the FXO ports; connect analog lines (phone and
Fax) to the FXS ports.
Firmware Version 1.0.1.22

Figure 1: UCM6102 Front View

Figure 2: UCM6102 Back View

UCM6102/6104/6108/6116 USER MANUAL Page 16 of 138