Saving The Configuration Changes; Rebooting From Remote; Software Upgrade; Upgrade Through Http - Grandstream Networks GXW-410x User Manual

5.2.2. Saving the Configuration Changes

Once a change is made, press the "Update" button in the Configuration Menu. The GXW-410x will then
display the following screen to confirm that the changes have been saved.
User is recommended to reboot or power cycle the GXW-410x after all the changes are made so that
those changes can take effect.

5.2.3. Rebooting from Remote

The administrator of the phone can remotely reboot the unit by pressing the "Reboot" button at the bottom
of the configuration menu. Once done, the following screen will be displayed to indicate that rebooting is
underway.
Grandstream Device Configuration
The device is rebooting now...
You may re-login by clicking on the link below in 30 seconds.
Click to re-login
All Rights Reserved Grandstream Networks, Inc. 2005
At this point, the user can re-login to the unit after waiting for about 30 seconds.

6. Software Upgrade

Software (or firmware) upgrade can be done either via TFTP or HTTP. The corresponding configuration
settings are on the configuration page. End users should NOT touch the configuration settings that are
useful for ITSPs.

6.1 Upgrade through HTTP

To upgrade firmware via HTTP, the field "Firmware Upgrade and Provisioning: Upgrade Via" needs to be
set to HTTP. The "Firmware Server Path" should be set to where the firmware files are located.
For example, the user can use the following URL in the Firmware Server Path:firmware.mycompany.com:
6688/Grandstream/1.0.0.29 where firmware.mycompany.com is the FQDN of the HTTP server. It can
also be in IP address format. ":6688" is the TCP port the HTTP server listening to, default http server
listens to port 80. "/Grandstream/1.0.0.29" is the RELATIVE directory to the root dir on HTTP web server.
Grandstream Networks, Inc. GXW-410x User's Manual Page 26 of 34
Firmware 1.0.0.32