Saving The Configuration Changes; Rebooting From Remote; Gxw410X User Manual - Grandstream Networks GXW410x User Manual

If selecting "Yes" the phone will use session timer when it receives inbound calls with session
Callee Request
Timer timer request.
If selecting "Yes" the phone will use session timer even if the remote party does not support
Force Timer
this feature. Selecting "No" will allow the phone to enable session timer only when the remote
party support this feature. To turn off Session Timer, select "No" for Caller Request Timer,
Callee Request Timer, and Force Timer.
UAC Specify As a Caller, select UAC to use the phone as the refresher, or UAS to use the Callee or proxy
Refresher server as the refresher.
UAS Specify
As a Callee, select UAC to use caller or proxy server as the refresher, or UAS to use the
Refresher
phone as the refresher.
Session Timer can be refreshed using INVITE method or UPDATE method. Select "Yes" to
Force INVITE
use INVITE method to refresh the session timer.
Enable 100rel
The use of the PRACK (Provisional Acknowledgment) method enables reliability to be offered
to SIP provisional responses (1xx series). This is very important if PSTN inter-networking is
to be supported. A user's request to use reliable provisional responses is invoked by the
100rel tag which is appended to the value of the required header of initial signalling
messages.
Default is NO. If set to YES, then for Attended Transfer, the "Refer-To" header uses the
Refer-to uses
transferred target's Contact header information.
Target Contact
INVITE Ring-no- In case incoming call has arrived from PSTN to VoIP and INVITE message was generated by
answer Timeout
GXW device, the call will be disconnected after preconfigured timeout if not answered by
VoIP extension.
Preferred Vocoder
The GXW410x supports up to 5 different Vocoder types including G.711 A-/U-law, GSM,
G.723.1, G.729A/B.
included with the same preference order in SDP message. The first Vocoder in this list can
be entered by choosing the appropriate option in "Choice 1". Similarly, the last Vocoder in
this list can be entered by choosing the appropriate option in "Choice 8".
Special Feature
Default is Standard. Choose the selection to meet some special requirements from Soft
Switch vendors like Nortel, Broadsoft, etc.
S C
AVING THE ONFIGURATION
When changes are made, press the "Update" button in the Configuration Menu. The GXW410x will
display the following screen to confirm that the changes have been saved. To activate changes, reboot
or power cycle the GXW410x after all changes are made.
R R
EBOOTING FROM EMOTE
The administrator can remotely reboot the unit by pressing the "Reboot" button at the bottom of the
configuration menu. The following screen will indicate that rebooting is underway.
The user can re-login to the unit after waiting for about 30 seconds.
Grandstream Networks, Inc.
The user can configure Vocoders in a preference list that will be
C
HANGES

GXW410x User Manual

Firmware 1.0.1.25
Page 25 of 33
Updated: 07/2008