Figure 11: Fxo Lines Configuration Definitions - Grandstream Networks GXW-410x User Manual

Figure 11: FXO Lines Configuration Definitions

Enable Current
Disconnect
AC Termination
Impedance
Silence Timeout
DTMF Digit
Length
DTMF Digit
Volume
DTMF Dial Pause Default value is 100ms.
Wait Dial-tone
Dialing Stage
Off-hook Auto
Dial
Grandstream Networks, Inc.
When set to Y, Current Disconnect is enabled. Certain PSTN Cos require
this to be enabled, in order to realize correct disconnect for PSTN side.
Default it Y.
Selects the impedance of the analog Line connected to the FXO port on the
GXW-410x.
Terminate call after long silence detected. Default is 60 seconds, max
65536.
Default value is 100ms.
Default value is -11dB.
It is recommended to set this to Y in case Dialing stage is set to 1.
Dialing stage can be set to 1 or 2. Note:- When set to 1, the Server needs
to be configured to allow forwarding and receipt of SIP messages from GXW
IP address directly.
This parameter allows users to configure a User ID or extension number to
be automatically dialed upon off-hook. Please note only the user part of the
SIP address needs to be entered here. The GXW-410x will automatically
append the '@' and host portion of the corresponding SIP address.
GXW-410x User's Manual
Firmware 1.0.0.32
Page 18 of 34