Grandstream Networks GXW410x User Manual
4 or 8 fxo ports
Hide thumbs
Also See for GXW410x:
- User manual (37 pages) ,
- Setup manual (13 pages) ,
- Quick installation manual (9 pages)
Related Manuals for Grandstream Networks GXW410x
Summary of Contents for Grandstream Networks GXW410x
- Page 1 Grandstream Networks, Inc. Analog IP Gateway GXW410x 4 or 8 FXO Ports GXW410x User Manual www.grandstream.com http:// Firmware Version 1.4.1.5 esupport.grandstream.com...
-
Page 2: Table Of Contents
PACKAGING ....................6 CONNECTING THE GXW410X......................6 APPLICATION DESCRIPTION ..............8 IP PBX / SIP SERVER WITH GXW410X....................8 FXS GATEWAY WITH GXW410X [NO SIP SERVER REQUIRED] ............9 FEATURES ....................11 SOFTWARE FEATURES OVERVIEW ....................11 HARDWARE SPECIFICATION ......................11 CONFIGURATION GUIDE ................ - Page 3 GXW410X USER MANUAL 1: DIAGRAM OF GXW410X BACK PANEL ..................6 IGURE 2: DIAGRAM OF GXW410X DISPLAY PANEL .................. 7 IGURE 3: FUNCTIONAL DIAGRAM OF IP-PBX & GXW410X ..............8 IGURE 4: GXW400 & GXW410 SCENARIO/TOLL- FREE CALLING BETWEEN LOCATIONS ....9 IGURE 5: SCREEN-SHOT OF VIDEO SURVEILLANCE* ................
-
Page 4: Gxw410X User Manual
GUI INTERFACES GXW410X USER MANUAL http://www.grandstream.com/products/gxw_series/gxw410x/documents/gxw410x_gui.zip 1. S CREENSHOT OF DVANCED ETTINGS ONFIGURATION 2. S CREENSHOT OF ASIC ETTINGS ONFIGURATION 3. S CREENSHOT OF HANNELS ONFIGURATION 4. S FXO L CREENSHOT OF INES ONFIGURATION 5. S CREENSHOT OF ROFILE ONFIGURATION 6. -
Page 5: Gxw410X User Manual
WELCOME Thank you for purchasing the Grandstream GXW410x IP Analog FXO Gateway. The GXW410x is a cost effective, easy to use and easy to configure IP communications solution for any business. The GXW410x supports popular voice codecs and is designed for full SIP compatibility and interoperability with 3... -
Page 6: Packaging
FXO ports to be connected to physical PSTN lines from a traditional PSTN PBX or PSTN Central Office. NOTE: GXW410x acts as bridge only, if a device is connected to the LAN port, this device will get an ip in same subnet as the WAN IP (NAT is disabled). -
Page 7: Figure 2: Diagram Of Gxw410X Display Panel
FIGURE 2: DIAGRAM OF GXW410X DISPLAY PANEL GXW410x Display LEDs port status TABLE 2: DEFINITIONS OF THE GXW DISPLAY PANEL Power LED Indicates Power. Remains ON when Power is connected and unit is turned ON. Ready LED Remains ON after boot-up. -
Page 8: Application Description
SIP User ID, Password, etc. Now, when you try to make calls from IP, the call will be routed to the SIP Server which will forward it to one of the SIP accounts on the GXW410x, which will then forward it to the PSTN line. -
Page 9: Fxs Gateway With Gxw410X [No Sip Server Required]
FXS GATEWAY WITH GXW410X [NO SIP SERVER REQUIRED] Alternatively, the GXW410x can be used without a SIP Server. You can use it in conjunction with a FXS Gateway (Ex. GXW400x) and still be able to originate and terminate calls from IP to PSTN and vice versa. - Page 10 Local SIP Listen port (For VOIP to PSTN calls) - 5060++ Profile 1 SIP Server - Set it to IP Address of GXW400x SIP Registration - No NAT traversal - No Grandstream Networks, Inc. GXW410x User Manual Page 10 of 32 Firmware Version 1.4.1.5 Last Updated: 5/2014...
-
Page 11: Features
FEATURES GXW410x is a next generation IP voice and video gateway that features full interoperability with leading IP-PBXs, SoftSwitches and SIP platforms. The Gateway series offers superb voice and video quality, traditional telephony functionality, simple configuration, feature rich functionality and an additional video port that enables the gateway to act like a video surveillance gateway. - Page 12 Polarity Reversal / Wink Yes (Detection only). The PSTN lines will need to be subscribed to PR service from the Service Provider. GXW410x: EN55022 Class B, CFR Part 15 Class B, EN55024; GXW4104: FCC, CE (in addition) Safety GXW410x: EN60950-1 GXW4108: UL60950-1 (in addition) Grandstream Networks, Inc.
-
Page 13: Configuration Guide
CONFIGURATION GUIDE CONFIGURATION WITH WEB BROWSER The GXW410x has an embedded Web server that will allow a user to configure the IP phone through any common web browser. Examples of GUI interfaces can be downloaded @ http://www.grandstream.com/products/gxw_series/gxw410x/documents/gxw410x_gui.zip ACCESSING THE WEB CONFIGURATION MENU 1. -
Page 14: Maintenance
Here “:6688” is the specific TCP port that the HTTP server is listening at, it can be omitted if using default port 80. Note: If Auto Upgrade is set to No, GXW410x will only do HTTP download once at boot Firmware Server Path IP address or domain name of firmware server. -
Page 15: Networks
DHCP mode: all the field values for the Static IP mode are not used (even though they are still saved in the Flash memory.) The GXW410x acquires its IP address from the first DHCP server it discovers from the LAN it is connected. -
Page 16: Settings
802.1p Priority value: Default value is 0. Range lies from 0 to 7. *** The above 2 settings need to be supported on the network and then configured accordingly on the GXW410x. Incorrect configuration will cause blocked access, which will result in Factory Reset as the only option to renew access. - Page 17 64 (x2.5ms) frames respectively. Local RTP port This parameter defines the local RTP-RTCP port pair the GXW410x will listen and transmit. It is the base RTP port for channel 0. When configured, channel 0 will use this port _value for RTP and the port_value+1 for its RTCP; channel 1 will use port_value+2 for RTP and port_value+3 for its RTCP and so on.
-
Page 18: Accounts
GXW410x will behave according to the STUN client specification. Under this mode, the embedded STUN client inside the GXW410x will attempt to detect if and what type of firewall/NAT it is sitting behind through communication with the specified STUN server. - Page 19 Call Settings User ID is Phone Number If the GXW410x has an assigned PSTN telephone number, this field should be set to “Yes”. Otherwise, set it to “No”. If “Yes” is set, a “user=phone” parameter will be attached to the “From” header in SIP request.
- Page 20 SIP account password needs to be entered here. Note: After entering the password, it will show up as blank but the password still remains active. Grandstream Networks, Inc. GXW410x User Manual Page 20 of 32 Firmware Version 1.4.1.5 Last Updated: 5/2014...
-
Page 21: Configuring The Fxo Channels
Default is No. If PSTN providers use the CAS then this option should be enabled. Supervision The Call Answer Supervision (CAS) is for billing—the telephone exchange and the Grandstream Networks, Inc. GXW410x User Manual Page 21 of 32 Firmware Version 1.4.1.5 Last Updated: 5/2014... - Page 22 AC Termination Impedance Selects the impedance of the analog line connected to the FXO port on the GXW410x. Here is some basic information which may be helpful for initial configuration: 600 Ohm – North America; 270 Ohm + (750 Ohm || 150 nF) -- Most of Europe 220 Ohm + (820 Ohm || 120 nF) –...
- Page 23 DTMF Digit Volume Default value is -11dB. DTMF Dial Pause Default value is 100ms. Please note that the value will be multiplied by 10ms. Grandstream Networks, Inc. GXW410x User Manual Page 23 of 32 Firmware Version 1.4.1.5 Last Updated: 5/2014...
-
Page 24: Line Analysis
Error Timeout This is the time the gateway will wait to exit the test mode, when something unexpected or an error has occurred. Grandstream Networks, Inc. GXW410x User Manual Page 24 of 32 Firmware Version 1.4.1.5 Last Updated: 5/2014... -
Page 25: Check Device Status
SAVING THE CONFIGURATION CHANGES Once a change is made, press the “Update” button in the Configuration Menu. The GXW410x will display the following screen to confirm that the changes have been saved. To activate changes, reboot or power cycle the GXW410x after all changes are made. -
Page 26: Video Surveillance
This application should be used in a LAN environment or when both sides have public IP address. NOTE: The following information is essential, only if your GXW410x's hardware (Revision 1) has a Video-IN Port, otherwise It will not show this functions. VIDEO SURVEILLANCE PROCEDURES ... -
Page 27: Figure 5: Screen-Shot Of Video Surveillance
FIGURE 5: SCREEN-SHOT OF VIDEO SURVEILLANCE* * PC client side running VLC as monitoring station Grandstream Networks, Inc. GXW410x User Manual Page 27 of 32 Firmware Version 1.4.1.5 Last Updated: 5/2014... -
Page 28: Software Upgrade
TFTP/HTTP/HTTPS fails for any reason (e.g. TFTP/HTTP/HTTPS server is not responding, there are no code image files available for upgrade, or checksum test fails, etc), the GXW410x will stop the TFTP/HTTP/HTTPS process and simply boot using the existing code image in the flash. -
Page 29: Configuration File Download
Microsoft IIS web server. CONFIGURATION FILE DOWNLOAD Grandstream SIP Device can be configured via Web Interface as well as via Configuration File through TFTP or HTTP/HTTPS. “Config Server Path” is the TFTP or HTTP/HTTPS server path for configuration file. It needs to be set to a valid URL, either in FQDN or IP address format. The “Config Server Path” can be same or different from the “Firmware Server Path”. -
Page 30: Restore Factory Default Setting
Restoring the Factory Default Setting will DELETE all configuration information of the phone. Please BACKUP or PRINT out all the settings before you approach to following steps. Grandstream will not take any responsibility if you lose all the parameters of setting and cannot connect to your VoIP service provider. -
Page 31: Examples Of Gxw410X Configurations
Scenario: a small business with traditional analog PBX lines and broadband access who want to extend their traditional PBX to virtually anywhere in the world, using the internet. (Any SIP End point, such as Grandstream BugeTone, HandyTone, GXP-2000 or GXV-3000 are needed in this scenario) FIGURE 7: GXW TO EXTEND A TRADITIONAL PBX SCENARIO... -
Page 32: Application 3: Using A Gxw For Pure Ip- Ip Communication Configuration
APPLICATION 3: USING A GXW FOR PURE IP- IP COMMUNICATION CONFIGURATION Scenario Four: The GXW410x offers an IP to IP pure IP Communications System configuration, where all locations use IP phones. FIGURE 7: USING A GXW FOR PURE IP- IP COMMUNICATION CONFIGURATION Branch A –...