Function Switches - Icom IC-706MKIIG Instruction Manual

1
PANEL DESCRIPTION
I
D
MENU F-1
Toggles the split function ON and OFF.
• "ä"appears when the split function is ON.
F-1
• The function of [F-3] changes to XFC when the
split function is ON.
➥ Toggles between VFO A and VFO B in
VFO mode.
➥ Toggles between transmission VFO and
F-2
reception VFO during split operation.
➥ Toggles between the transmit and
receive frequencies (and modes) of
memory channels when the split func-
tion is turned ON.
Equalizes the frequency and operating
mode of the two VFO's.
F-3
• The rear (undisplayed) frequency and operat-
ing mode are equalized to the front (displayed)
VFO frequency and operating mode.
Appears when the split function is turned
ON—monitors the transmit frequency
when pushed and held.
F-3
• While pushed, the transmit frequency can be
changed with the main dial.
D
MENU F-1
Stores the displayed frequency and oper-
ating mode into the displayed memory
channel.
F-1
Transfers the frequency and operating
mode in the selected memory channel to a
F-2 VFO.
(p. 39)
Toggles between VFO and memory
modes.
F-3
3
F-2
(p. 29)
(p. 16)
(p. 16)
(p. 29)
F-2
(in memory mode)
(p. 40)
(p. 41)
Clears the selected memory channel's
contents.
• "}" appears.
F-2
D
F-3
MENU
Toggles
filter—push for 2 sec.) ON and OFF.
• "ã"appears when the narrow filter is ON; "ç"
F-1
• An optional narrow filter and presetting in initial
Turns the noise blanker ON and OFF.
• The noise blanker does not function in FM and
F-2
Selects the type of meter displayed (dur-
ing transmit) in the function display.
F-3
• Power, ALC or SWR metering can be selected.
• Only an S-meter is available for receive.
D
DURING SSB/AM OPERATION:
MENU
F-3
DURING CW OPERATION:
MENU
DURING RTTY OPERATION:
MENU
DURING FM OPERATION:
MENU
(p. 39)
F-1 F-2
(p. 23)
the narrow filter
appears when the wide filter is ON.
set mode (p. 51) is necessary to use the fol-
lowing:
CW/RTTY narrow: FL-100, FL-101 or FL-232
SSB narrow: FL-223
SSB wide: FL-103
(p. 21)
WFM modes; the "AM Noise blanker" item in
initial set mode must be set to ON for the noise
blanker to work in AM mode (p. 53).
(p. 25)
F-1 F-2
F-1 F-2
F-1 F-2
F-1 F-2
F-3
(or wide
F-3
F-3
F-3
F-3