Icom IC-706MKIIG Instruction Manual page 56

7
SET MODE
When this item is set to "on 1", the tone encoder is
not set when the auto repeater is activated; when set
to "on 2" the auto repeater function also sets the
tone encoder on.
This item sets the scan resume function ON or OFF.
ON: scan resumes 10 sec. after stopping on a signal
(or 2 sec. after a signal disappears); OFF: scan does
not resume after stopping on a signal. For the priority
watch, setting to OFF pauses the watch until signal
disappears and scan resumes.
This item sets the rate at which channels or frequen-
cies are scanned during scan operations. High or low
can be selected.
This item sets the rate at which frequencies are
scanned through when the [UP]/[DN] switches are
pushed and held. High or low can be selected.
When this item is set to ON, the noise blanker func-
tion is available in AM mode. This is useful when com-
municating in AM mode (the noise blanker function
should not be used when listening to regular AM
broadcasts as it may degrade the received audio).
This item sets the number of memo pad channels
available. 5 or 10 memo pads can be set.
When this item is set to "on," the set output power is
briefly displayed when turning power ON (RIT and
auto power off settings are also displayed if activat-
ed); when turned "oFF," the display goes directly to
frequency indication at power ON.
53
Auto repeater function OFF
(default).
Scan resume function is
turned ON (default).
Scan speed is set to high
(default).
Up/down speed is set to
high (default).
Noise blanker available
(default)
5 memo pads are available
(default).
Power on check ON
(default)
Auto repeater function ON,
tone encoder OFF.
Scan resume function is
turned OFF.
Scan speed is set to low.
Up/down speed is set to low.
Noise blanker not available
10 memo pads are available.
Power on check OFF