Frequency Setting; Band Selection; Programmable Tuning Steps; 1Hz And 10 Hz Tuning Steps - Icom IC-706MKIIG Instruction Manual

3

FREQUENCY SETTING

I
•
All HF ham bands, the 50 MHz band, the 144 MHz
band and a general coverage receiver band are
included in the IC-706MKIIG.
Push [ BAND]/[
(Y)
band.
• Pushing [ BAND]/[
(Y)
through the available bands.
The band stacking register can also be used to
select bands. Refer to p. 19.
•
Programmable tuning steps are available to suit your
operating requirements.
These tuning steps are:
• Independently selectable for each mode
• Selectable from 0.01 (FM/WFM/AM only), 0.1, 1, 5,
9, 10, 12.5, 15, 20 and 100 kHz
➀
Push [TS] one or more times until the programma-
ble tuning step indicator, "
1 kHz digit.
•Rotating the main dial changes the frequency accord-
ing to the set tuning step.
➁
Push [TS] for 2 sec. while the programmable tun-
ing step indicator appears to enter the tuning step
selection mode.
•
➂
Rotate the main dial to set the desired tuning step.
•Change the mode and select tuning steps for other
modes, if desired.
➃
Push [TS] to exit the tuning step selection mode.
➄
Rotate the main dial to change the frequency
according to the set tuning step.
•
When neither the quick tuning step or programmable
tuning step, " Z
changes the frequency in increments of 1 or 10 Hz.
These tuning steps are only available in SSB, CW
and RTTY modes.
➀
Select SSB, CW or RTTY mode if necessary.
➁
Push [TS] for 2 sec. to toggle between the 1 and
10 Hz step settings.
•When the 1 Hz step is selected, the 1 Hz digit appears
in the frequency indication; when the 10 Hz step is
selected, the 1 Hz digit disappears from the frequency
indication.
17
BAND] to select the desired
(Z)
BAND] continuously scrolls
(Z)
Z ," appears above the
appears.
," appear, rotating the main dial
LSB
Z
USB
USB
VFO A
S1 3 5 7 9 20 40 60dB
P 5 10
O
USB
USB
VFO A
Push TS for 2 sec.
USB
VFO A
FM
USB
Z
USB
Programmable tuning
step indicator
CH
10 kHz tuning step is
selected for USB
operation.
Rotating the main dial
changes the frequency
in 10 Hz steps.
Rotating the main dial
changes the frequency
in 1 Hz steps.