Scan Types; Preparation; Programmed Scan; Priority Watch - Icom IC-706MKIIG Instruction Manual

5
MEMORY AND SCAN OPERATION
I

PROGRAMMED SCAN

Repeatedly scans between two scan edge frequencies
(scan edge memory channels 1A and 1B).
Scan edge 1A or 1B
This scan operates in VFO mode.
MEMORY SCAN
Repeatedly scans all programmed memory channels.
Mch 2
Mch 1
S (select)
Mch 99
S (select)
This scan operates in memory mode.
I
•
For programmed scan: Program scan edge frequen-
cies into scan edge memory channels 1A and 1B
(p. 34).
For memory scan: Program 2 or more memory chan-
nels except scan edge memory channels.
For memory select scan: Designate 2 or more memory
channels as select memory channels—select a mem-
ory channel, then push [
(memory mode) to designate the channel as a select
memory channel.
For priority watch: Program 1 memory channel to be
watched.
•
You can select the scan to resume or cancel when
detecting a signal, in initial set mode, item 21. Scan
resume ON/OFF must be set before operating a scan.
See p. 53 for ON/OFF setting and scan resume con-
dition details.
43
Scan
Scan edge 1B or 1A
Jump
BLANK
S (select)
Mch 3 Mch 4
Mch 5
S (select)
Mch 7 Mch 6
S (select)
] in the display
(F-2)

PRIORITY WATCH

Checks for signals on a memory or call channel while
operating on a VFO frequency.
Memory channel watch
VFO
Memory
frequency channel
This scan operates in VFO mode.
SELECTED MEMORY SCAN
Repeatedly scans all selected memory channels.
S (select)
Mch 2 Mch 3
Mch 1
S (select)
Mch 99 Mch 7
S (select) S (select)
This scan operates in memory mode.
•
Scan speed can be selected from 2 levels, high or low,
in initial set mode. See p. 47 for details.
•
The scan continues
until it is stopped
manually, and does
not pause even if it
detects signals.
This is not applicable
when the scan
resume is OFF and a
programmable step
(more than 1 kHz) is
selected.
Scan stops when detecting a signal.
If you set scan resume ON in initial set mode,
the scan pauses for 10 sec. when detecting a
signal, then resumes. When a signal disap-
pears while scan is paused, scan resumes 2
sec. later.
Call channel watch
VFO
Call
frequency channel
BLANK
Mch 4
Mch 5
S (select)
Mch 6
Scan pauses on each
channel when the
scan resume is ON;
not applicable when
OFF.