I Verifying Self-Id; I Self Testing; I Telephone Number Input - Icom IC-M801E Instruction Manual

10
DSC MENU OPERATION

I Verifying self-ID

➥ During setup select menu indication, rotate [CH] to
select "
play the programmed MMSI ID (self-ID).
➥ Push [DSC] to select DSC watch mode.
➥ Push [MODE
SET
➥ Rotate [CH] to select "
• Push [MODE
SET
push [FREQ/CH] to return to the select screen.

I Self testing

According to regulations, the IC-M801E has a self test-
ing capability to check the internal AFSK encoder and
decoder circuits without signal transmission via the
transceiver.
q During DSC watch mode, push [MODE set] to se-
lect DSC menu.
w Rotate [CH] to select "
[ENT] to start the self test.
e "
" is displayed when both encoder and decoder
functioning correctly.

I Telephone number input

q During DSC menu indication, rotate [CH] to select
" " then push [ENT] to select setup menu.
• The select screen is displayed.
w Rotate [CH] to select the "
[ENT].
• The telephone number list screen is displayed.
• 10 telephone number memories are available.
Ç
40
" then push [ENT] to dis-
] to select DSC menu.
" then push [ENT].
] to return to DSC watch mode, or
" then push
," then push
If the circuit has a problem, the following message
is displayed.
• Both or either message is/are displayed depending on
problem.
: DSC receiver's decoder circuit has a
problem.
: Transceiver's encoder or decoder
circuit has a problem.
e Rotate [CH] to select "
• The call/traffic/scan frequency setup screen is dis-
played.
r Push the numeral keys to input the desired 10-
character telephone number name, and telephone
number, then push [ENT].
• Rotate [CH] to move the cursor.
" then push [ENT].