Panel Description - Icom IC-F5062D Instruction Manual

1

PANEL DESCRIPTION

HOOK SCAN
When the Hook Scan functon s pre-programmed, push ths
key to dsable the functon. Push ths key agan to enable the
functon.
USER SET MODE
➥ Hold down for 1 second to enter the User Set mode.
• In the User Set mode, push ths key to select an tem that s ena-
bled by your dealer, and change the value or settng by pushng
[CH Up] or [CH Down].
➥ Hold down for 1 second agan to ext the User Set mode.
The User Set mode s also avalable usng the Power ON
functon. Refer to page 12.
10Key ENT
Push to enable the mcrophone's 10-keypad operaton.
• Dependng on the pre-programmed settngs, 10-keypad can be
used to select a desred memory channel, ID lst number (dPMR),
TX status (BIIS, dPMR) or Short Data Message (dPMR), or enter a
desred TX code (5-tone) or ID (dPMR).
OPT 1 OUT, OPT 2 OUT, OPT 3 OUT
Push to output the control sgnal to the opton connector. Ask
your dealer for detals.
OPT 1 MOMENTARY, OPT 2 MOMENTARY,
OPT 3 MOMENTARY
Outputs the control sgnal to the opton connector whle hold-
ng down ths key. Ask your dealer for detals.
7
POWER OFF EMERGENCY
Whle holdng down ths key, turn the power OFF to actvate
the Power OFF Emergency functon.
Ths functon makes the transcever transmt emergency calls,
even though t appears to be powered OFF. (p. 15)