Call Procedure; ReceVNg And TransmTtNg - Icom IC-F5062D Instruction Manual

2
BASIC OPERATION

■ Call procedure

When your system employs tone sgnallng (excludng CTCSS
and DTCS), a call procedure may be necessary pror to voce
transmsson. The tone sgnallng employed may be a selec-
tve callng system, whch allows you to call specfic staton(s)
only, and prevent unwanted statons from contactng you.
q Select the desred TX code channel accordng to your sys-
tem operator's nstructons.
• Ths may not be necessary, dependng on programmng.
• Refer to pages 10 and 11 for detals.
w Push [Call] (assgned to one of the dealer programmable
keys).
e After transmttng, the remander of your communcaton
can be carred out n the normal fashon.
Selective calling
9
Non-selective calling
■ Receiving and transmitting
Receiving:
q Hold down [ ] for 1 second to turn the power ON.
w Push [CH Up] or [CH Down] to select a channel.
e When recevng a call, rotate [VOL] to adjust the audo
output level to a comfortable lstenng level.
NOTE: Dependng on the pre-programmed settngs, the
transcever automatcally transmts the mcrophone audo
for the pre-programmed tme perod when a matchng sg-
nal s receved.
• The HM-148G or HM-152
hand microphone
Transmitting:
Wat for the channel to become clear to avod nterference.
q Take the mcrophone OFF hook.
• 2/5-tone mute may be released. (The 'Audble' (unmute) mode
s selected and LED ndcator lghts green.)
• The Prorty A channel may be automatcally selected.
w Wat for the channel to become clear.
• The channel s busy when the LED ndcator lghts green.
e Whle holdng down [PTT], speak nto the mcrophone at
your normal voce level.
r Release [PTT] to return to receve.
IMPORTANT: To maxmze the readablty of your sgnal;
1. Pause brefly after pushng [PTT].
2. Hold the mcrophone 5 to 10 cm from your mouth, then
speak nto the mcrophone at a normal voce level.
s requred.