D Transmitting Notes; D Tx Code Channel Selection - Icom IC-F5062D Instruction Manual

D Transmitting notes

• Transmit inhibit function
The transcever has several nhbt functons whch restrct
transmsson under the followng condtons:
- The channel s n the 'Inaudble' (mute) mode ("
does not appear.)
ble con)
- The channel s busy. However, dependng on the pre-
programmed settngs, you can transmt when a call s re-
ceved that ncludes an unmatchng (or matchng) CTCSS
(DTCS), colour code, or Indvdual or Talkgroup ID.
- The selected channel s a 'receve only' channel.
• Time-out timer
If contnuous transmsson exceeds the pre-programmed
tme-out tmer lmt, the transmsson s cut off.
• Penalty timer
After the transmsson s cut off by the tme-out tmer, trans-
msson s further nhbted for the pre-programmed penalty
tmer perod.

D TX code channel selection

If the transcever has a key assgned to TX Code CH Select,
the ndcaton can be toggled between the operatng channel
number (or name) and TX code channel number (or name).
" When the TX code channel number (or name) s dsplayed,
(Aud-
[CH Up] or [CH Down] selects the TX code channel.
USING [TX CODE CH SELECT]:
q Push [TX Code CH Select]— a TX code channel number
(or name) appears.
w Push [CH Up] or [CH Down] to select the desred TX code
channel.
e After selectng, push [TX Code CH Select] to set.
• Return to the stand-by mode.
r Push [Call] to transmt the selected TX code.
USING [TX CODE CH UP]/[TX CODE CH DOWN]:
If the transcever has a key assgned to TX Code CH Up or
TX Code CH Down, the programmed TX code channel can
be drectly selected when pushed.
2
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
10