Figure 63 System/Network Setup Screen-System, Page 1 Of 2 - Emerson Liebert XDP User Manual

Supply Refrigerant Sensor 0%—Allows the sensor reading to be calibrated at the lowest reading of
the sensor. This calibration changes the start point of the sensor reading.
Supply Refrigerant Sensor 100%—Allows the sensor reading to be calibrated at the highest
reading of the sensor. This calibration changes the end point of the sensor reading.
Figure 63 System/Network Setup screen—System, page 1 of 2
SYSTEM/NETWORK SETUP (page 1 of 2)
S801
S802
S803
S804
S805
S806
S807
S808
S809
S810
S811
Number of Connected Units—Shows the number of displays connected. This is always 1.
Configuration Safe—Saves or loads configuration settings for the display that have been modified
from the factory defaults to an internal file that can be downloaded/uploaded using the Liebert iCOM
Service Tool. Selecting Save will write the settings to the internal storage file and selecting Load will
write the settings from the internal storage file to the application software. The internal file is
updated automatically every 12 hours.
Network Safe—Saves or loads network settings for the display that have been modified from the
factory defaults to an internal file that can be downloaded/uploaded using the Liebert iCOM Service
Tool. Selecting Save will write the settings to the internal storage file and selecting Load will write
the settings from the internal storage file to the application software.
SW Version—Contains the application software version loaded onto the Liebert iCOM display.
PASSWORD (Actual Level 0)
Number of Connected Units
Configuration Safe
Network Safe
SW Version
for next/previous unit
then to change parameter
Liebert iCOM Control—Firmware Version XP1.00.010.STD
OK
OK
XP1.00.010.STD
to select parameter
to confirm
57
SYSTEM
????
1
No
No