System Setup - Emerson DataMate 3000 Series User Manual

42 Chapter 5 Microprocessor Control

5.9.1 System Setup

System settings will not be lost when power fails. Select System Setup from the
System Menu to display the items listed in Figure 5-24.
Use Up/Down buttons to move the cursor to Monitor as shown in Figure 5-24, and
press Enter to display the sub-menu, as shown in Figure 5-25. Press Enter to set
the system address for communicating with a host. The setting range is 1~244 and
the default value is 1.
1. Use Up/Down buttons to move the cursor to Teamwork in the System Setup
menu, and press Enter to display the Teamwork sub-menu, as shown in Figure
5-26. Use Up/Down buttons to move the cursor to Cntl Brd, and press Enter to set
the control board number for communication with other control boards. It can be set
from 0 to 15, and the default value is 0. Use Up/Down buttons to move the cursor to
Unit No, and press Enter to set the unit number. It can be set from 0 to 15, and the
default value is 0.
2. Use Up/Down buttons to move the cursor to Start Delay in the System Setup
menu, and press Enter to display the sub-menu, as shown in Figure 5-27. The
default values and the setting ranges of the delays in Figure 5-27 are listed in Table
5-1.
M o n i t o r
T e a m w o r k
S t a r t D e l a y
C / F D e g r e e s
Figure 5-24 System Setup sub-menu
U n i t
Figure 5-25 Monitor sub-menu
C n t l
U n i t
Figure 5-26 Teamwork sub-menu
DataMate 3000 Series Air Conditioner User Manual
H u m C o n t r o l
B e e p e r
B a c k l i g h t
C o n t r a s t
N o
B r d
N o
R E L
O N
O N
3 0 %
1
1
1