Entering The Password; Figure 27 Entering The Password - Emerson Liebert XDP User Manual

4.3.3

Entering the Password

Most settings in the Liebert iCOM are protected by a factory-set password, 1490. To enter the
password:
1. From the home screen, press the Enter key to view the User Menu (see Figure 29).
2. Press Enter again to highlight the first icon.
3. Use the keyboard's arrow keys to move to the icon for the data you wish to change.
4. Once that icon is highlighted, press Enter again to open that menu.
5. Press Enter to highlight the Password line.
6. With the Password line highlighted, press Enter to highlight the first digit in the password
7. Enter the password, 1490.
Use the Up and Down arrow keys to select a numeral for the first digit of the password.
Move to the next digit of the password with the Right arrow key.
Select the numerals for all four digits with the same process.
8. After all four digits of the password have been entered, press the Enter key.
NOTE
Do not press the ESC key or the Liebert iCOM will move to the previous screen and the
password must be re-entered before changes may be made.

Figure 27 Entering the password

Password command line—highlight
by pressing Enter
SETPOINTS
U101
U102
U103
U104
U105
U106
U107
U108
U109
U110
U111
PASSWORD (Actual Level 0)
Min Room Temperature Setpoint
for next/previous unit
then to change parameter
Liebert iCOM Control—Firmware Version XP1.00.010.STD
After highlighting the Password command line, press
Enter again to highlight the first digit. Use the Up and
Down arrow keys to change the first digit. Move to the
next digit in the Password with the right arrow.
UNIT 01
to select parameter
to confirm
30
????
68.0°F