Procedure For The Reinstallation - Oce VarioPrint 1105 User Manual

3

Procedure for the reinstallation

1
Check the shaft of the new pick-up roller unit to see if it is provided with
the bearing.
2
Insert the shaft of the new pick-up roller unit into the notch (1) and
notch (2) of the bearing.
3
Slide the shaft of the new pick-up roller unit to the rear side and insert
it into the coupling.
Note
Be sure to fit the shaft of the pick-up roller unit in the coupling.
4
Slide the one-way clutch to the inside and set it to the notch (1) of the
bearing.
5
Slide the bearing to the inside and set it to the notch (2) of the bearing.
6
Attach the C-ring (1) and C-ring (2).
3-4
C-ring (2)
Bearing
Notch (1)
Coupling
Notch (2)
Spring
Pick-up roller unit
One-way clutch
C-ring (1)
CMS Replacement instructions
DF-603