Introduction
1.5
Count reset method of CMS corresponding parts
Count checking method
After registration of CMS corresponding part name/part number/limit value,
when count of the part reaches to its limit value, "*" mark appears beside the
count No. displayed on the [CMS parts count] screen and the item is dis-
played in red.
Note
Whether a part is reached to its limit value or not cannot be confirmed
with normal mode.
Be sure to check the [CMS parts count] screen.
Count reset procedure
After replacement of a part which is reached to its limit value, clear the count
by the following procedure.
1
Touch [Utility/Counter].
2
Touch [CMS PartsCount].
3
Touch [Setting].
-
By touching [Next] or [Previous], previous or next screen can be
displayed.
4
Touch [+] or [,] on the CMS Parts Count screen to select No. of item
to be reset.
CMS Replacement instructions
1
1-11