Stamp - Ricoh 3245 - Type Print Server Facsimile Reference Manual

Other Transmission Features

Stamp

The optional ADF is required.
When sending a fax message using
the ADF, the machine can stamp a cir-
cle mark at the bottom of the original.
When sending a two-sided docu-
ment, the document is marked at the
bottom of the front page and top of
the rear page. This stamp indicates
that the original has been successfully
stored in memory for Memory Trans-
mission, or successfully sent by Im-
4
mediate Transmission.
Note
❒ Stamp only works when scanning
from the ADF.
❒ When the stamp starts getting light-
er, replace the cartridge. See "Re-
placing the Stamp Cartridge",
General Settings Guide.
❒ If a page was not stamped even
though the Stamp function is
turned on, you need to resend that
page.
❒ If you use this function often, you
can set the default in General Set-
tings and Adjustment so that this
function is always on. In this case,
Stamp can easily be turned off for
any single transmission by press-
ing [Stamp]. See p.144 "General Set-
tings/Adjustment".
72
❒ A paper jam during Parallel Mem-
ory Transmission may cause the
transmission to be failed even if
stamping is performed.
❒ You cannot turn the Stamp func-
tion on or off while a document is
being scanned.
A A A A
Place the original, and then select
the scan settings you require.
Reference
p.11 "Placing Originals", Fac-
simile Reference <Basic Features>
p.28 "Scan Settings", Facsimile
Reference <Basic Features>
B B B B
Press [Sub TX Mode].
C C C C
Press [Stamp], and then press [OK].
Note
❒ To cancel the stamp, press [Stamp]
again before pressing [OK].
D D D D
Specify the destination, and then
press the { { { { Start} } } } key.