Table of Contents
Advertisement
>
The selection is taken over by pressing the OK key.
>
Select the line LNB Config. with the arrow keys up/down and acknowledge with OK.
>
Set the data of the test transponder and of the used LNB in this menu as described in
Section 6.4.3.
>
After you have set the test transponder, press the Back key to return to the menu to
set the motor antenna.
>
Now select the field to enter the orbital position with the arrow keys.
>
Enter the orbital position of the user satellite with the numeric keyboard.
>
Now, by pressing OK, enter whether this is a Western (W) or an Eastern (E) orbital
position.
If the geo positioning is activated (Section 9.2), you can only rotate the dish by means
of the Rotate to sat function (Section 9.4.1) to the programmed user satellite position.
You must rotate the dish manually (Section 9.3.2.2) to the required satellite position, if the
geo positioning is deactivated.
As soon as the dish has completed its rotation, the set test transponder checks, whether a
signal can be received at this position. This detects, whether the position to be saved is a
pre-programmed position. For this, observe the pop-up menu in the lower section of the
menu.
9.3.2 Aligning the satellite antenna
In order to align the antenna to the required satellite or in order to be able to determine whet-
her you can receive the satellite in the set position a test transponder has been set for every
satellite. Only when the signal strength and the signal quality of this test transponder is dis-
played, precise alignment of the antenna will be possible.
9.3.2.1 Test transponder/LNB-configuration
In order to change the data of the respective test transponder, proceed as follows:
>
Select the Current satellite list field with the arrow keys.
>
Press the OK key to open the satellite list.
>
Select the satellite position, whose data you would like to change with the arrow
keys up/down.
>
Confirm with OK.
>
Now, using the arrow keys, highlight the field LNB Config. and press the OK key.
Select the channel that you would like to add to the list with the arrow keys
up/down.
>
Enter the data of the test transponder and of the used LNB in this menu as described
in Section 6.4.3.
>
Presssing the key Return, returns you to the setting of the motor antenna.
9.3.2.2 Aligning the antenna manually
The optimal alignment to the required position can be carried out with the display of the signal
strength and signal quality. Align the dish in such a way, that both bars show maximal strength.
50
Advertisement
Table of Contents
