First Installation; Initial Installation - TechniSat DigiPlus STR 1 Operating Manual

5 Initial installation

After reading the safety notes and having connected the device as described in Chapter 4,
turn the device on as described in Chapter 7. Upon initial start-up of the device, the start
screen of the installation assistant AutoInstall will appear. The installation assistant helps
you to carry out the most important settings on the digital receiver.
The installation assistant explains, which settings can be made at each installation stage.
You can abort the initial installation by pressing the red function keyon the startup screen of
the installation assistant. In the following installation steps, you can accept the carried out
settings by pressing the green control key, which takes you to the following installation step.
By pressing the red control key, you can return to the previous installation step. Here you are
able to correct any input errors.
If the initial setting is not carried out or is aborted, your device will start with a standard set-
ting.
The initial installation demonstrated here is only an example. The precise
initial installation procedure depends on the settings you have accomplished. Therefore plea-
se follow the instructions on the screen carefully.
Operating language
> When starting the installation assistant, you will first see the selection menu
Operating Language.
> Highlight the required operating language with arrow keys up/down
> Confirm with the green control key Accept.
Setting the country
> Select your county with the arrow keys The time zone and the sorting of the pro-
gramme list will be set according to this selection.
> Confirm with the green function key Accept in order to accept the selection and to
continue to the selection of the antenna signals.
Antenna configuration
In this installation step you can adjust the digital receiver to the configuration of your anenna.
> If you would like to accept the standard setting of the antenna, press the green
function key Accept. In this case, continue with Section "Software Update".
> If the configuration of your receiver does not correspond with the standard setting,
press the yellow function key Change.
> Carry out the antenna setting in line with your receiver as described in Section 6.4.
> Pressing the red Return function key, returns you to the antenna configuration over-
view.
> Confirm with the green function key Accept in order to accept the selection and to
be taken to the selection of the antenna signals.
Software update
After you have carried out the station search function, the digital receiver checks via cable
whether new software is available for the device. If new software is available, you can auto-
matically carry out a software update.
12