Replacing The Fuser Assembly - Xerox WorkCentre 7425 User Manual
Workcentre 7400 series
Hide thumbs
Also See for WorkCentre 7425:
- Ghid de utilizare (280 pages) ,
- Manual d'utilisation (276 pages) ,
- Quick use manual (88 pages)
Table of Contents
Advertisement
Maintenance
Replacing the Fuser Assembly
The printer will display a message on the touch screen when the fuser assembly needs to be replaced.
Caution:
Do not perform this procedure when the printer is copying or printing.
1. Power the printer OFF using the power switch located on the front, ride side, below control panel.
2. Open Tray 5 (Bypass) (1). While lifting up the release lever, open the top left cover (2).
Warning:
The fuser assembly is hot during normal operation. To avoid potential personal injury,
wait 40 minutes for the fuser assembly to cool before proceeding.
3. Turn the two orange screws on either side of the fuser assembly counterclockwise until they are
completely loosened.
Note:
The screws do not detach from the printer.
168
WorkCentre 7425/7428/7435
User Guide
wc74xx-01
wc74xx-172
Advertisement
Table of Contents
Troubleshooting
