System Ip - TP-Link TL-SL5428E User Manual

The following entries are displayed on this screen:
DST Config

DST Status:
Predefined Mode:
Recurring Mode:
Date Mode:
Note:
1. When disable the DST, the predefined mode, recurring mode and date mode cannot be
configured.
2. When enable the DST, the default daylight saving time is of European in predefined mode.

4.1.5 System IP

Each device in the network possesses a unique IP Address. You can log on to the Web
management page to operate the switch using this IP Address. The switch supports three modes
to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a new mode
will replace the original IP address. On this page you can configure the system IP of the switch.
Choose the menu System→System Info→System IP to load the following page.
Enable or Disable DST.
Select a predefined DST configuration:
 USA: First Sunday in April, 02:00 ~ Last Sunday in
October, 02:00.
 Australia: First Sunday in October, 02:00 ~ First Sunday in
April, 03:00.
 European: Last Sunday in March, 01:00 ~ Last Sunday in
October, 01:00.
 New Zealand: First Sunday in October, 02:00 ~ Last
Sunday in March, 03:00.
Specify the DST configuration in recurring mode. This
configuration is recurring in use:
 Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
 Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Specify the DST configuration in Date mode. This configuration
is one-off in use:
 Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
 Start/End Time: Select starting time and ending time of
Daylight Saving Time.
15