System Ip - TP-Link TL-SL3428 User Manual

Date Mode:
Note:
1. When the DST is disabled, the predefined mode, recurring mode and date mode cannot be
configured.
2. When the DST is enabled, the default daylight saving time is of Europe in predefined mode.

4.1.5 System IP

Each device in the network possesses a unique IP address. You can log on to the Web
management page to operate the switch using this IP address. The switch supports three modes
to obtain an IP address: Static IP, DHCP and BOOTP. The IP address obtained using a new mode
will replace the original IP address. On this page you can configure the system IP of the switch.
Choose the menu System→System Info→System IP to load the following page.
The following entries are displayed on this screen:
IP Config

MAC Address:
IP Address Mode:
Specify the DST configuration in Date mode. This configuration
is recurring in use:
 Offset: Specify the time adding in minutes when Daylight
Saving Time comes.
 Start/End Time: Select starting time and ending time of
Daylight Saving Time.
Figure 4-7 System IP
Displays MAC address of the switch.
Select the mode to obtain IP address for the switch.
Static IP: When this option is selected, you should enter IP

Address, Subnet Mask and Default Gateway manually.
DHCP: When this option is selected, the switch will obtain

network parameters from the DHCP Server.
BOOTP: When this option is selected, the switch will obtain

network parameters from the BOOTP Server.
16