System Timeout; Remote Management Screens; Www Screen; Telnet Screen - ZyXEL Communications P-2024 User Manual

Chapter 9 Remote Management

9.1.2 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds).
The P-2024 automatically logs you out if the management session remains idle for longer than
this timeout period. The management session does not time out when a statistics screen is
polling. You can change the timeout period in the Maintenance > System > General screen.

9.2 Remote Management Screens

9.2.1 WWW Screen

Use this screen to control HTTP access to your P-2024. To access this screen, click
Management > Remote MGMT > WWW.
Figure 36 Management > Remote MGMT > WWW
Each field is described in the following table.
Table 32 Management > Remote MGMT > WWW
LABEL
Server Port
Server Access
Secured Client IP
Address
Apply
Reset

9.2.2 Telnet Screen

Use this screen to control Telnet access to your P-2024. To access this screen, click
Management > Remote MGMT > Telnet.
94
DESCRIPTION
Enter the port number this service can use to access the P-2024. The computer
must use the same port number.
Select the interface(s) through which a computer may access the P-2024 using
this service.
Select All to allow any computer to access the P-2024 using this service.
Select Selected to only allow the computer with the IP address that you specify to
access the P-2024 using this service.
Click this to save your changes and to apply them to the P-2024.
Click this to set every field in this screen to its last-saved value.
P-2024 User's Guide