Rip; Chapter 30 Rip; Figure 75 Rip; Table 61 Rip - ZyXEL Communications MI-7248 User Manual

C
H A P T E R

30.1 RIP

RIP (Routing Information Protocol) allows a routing device to exchange routing information
with other routers. Use this screen to configure RIP on the switch. To open this screen, click IP
Application > RIP. You cannot manually configure a new entry. Each entry in the table is
automatically created when you configure a new IP domain in the IP Setup screen. See
Section 10.2 on page

Figure 75 RIP

The following table describes the labels in this screen.

Table 61 RIP

LABEL DESCRIPTION
Active Select this check box to enable RIP on the switch.
Index This field displays the index number of an IP interface.
Network This field displays the IP interface configured on the switch.
Refer to the section on IP Setup for more information on configuring IP domains.
Direction Select the RIP direction from the drop-down list box. Choices are Outgoing, Incoming,
Both and None.
Both: The switch will broadcast its routing table periodically and incorporate the RIP
information that it receives.
Incoming: The switch will not send any RIP packets but will accept all RIP packets
received.
Outgoing: the switch will send out RIP packets but will not accept any RIP packets
received.
None: The switch will not send any RIP packets and will ignore any RIP packets received.
MS-7206 User's Guide
73.
30

RIP

173