Figure 118 Snmp; Table 90 Snmp - ZyXEL Communications MI-7248 User Manual

Figure 118 SNMP

The following table describes the labels in this screen.

Table 90 SNMP

LABEL
General Setting
Version
Get Community
Set Community
Trap Community Enter the Trap Community string, which is the password sent with each trap to the
Trap Destination
Version
IP
MS-7206 User's Guide
DESCRIPTION
Use this section to specify the SNMP version and community (password) values.
Select the SNMP version for the switch. The SNMP version on the MM-7201 must
match the version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP
version 3 (v3) or both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version
1.
Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version
2c or lower.
Enter the Set Community, which is the password for incoming Set- requests from
the management station.
The Set Community string is only used by SNMP managers using SNMP version
2c or lower.
SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP version
2c or lower.
Use this section to configure where to send SNMP traps from the switch.
Specify the version of the SNMP trap messages.
Enter the IP addresses of up to four managers to send your SNMP traps to.
Chapter 38 Access Control
229