Figure 101 Vrrp Configuration; Table 79 Vrrp Configuration - ZyXEL Communications MI-7248 User Manual

Chapter 36 VRRP

Figure 101 VRRP Configuration

The following table describes the labels in this screen.

Table 79 VRRP Configuration

LABEL
Index
Network
Authentication
Key
Apply
Cancel
Active
Name
Network
Virtual Router
ID
208
DESCRIPTION
This field displays the index number of an entry.
This field displays the IP address and number of subnet mask bit of an IP domain.
Select None to disable authentication. This is the default setting.
Select Simple to use a simple password to authenticate VRRP packet exchanges on
this interface.
When you select Simple in the Authentication field, enter a password key (up to
eight printable English keyboard character long) in this field.
Click Apply to save your changes to the switch's run-time memory. The switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to discard all changes made in this table.
Use this section to configure various VRRP parameters.
Select this option to enable this VRRP entry.
Enter a descriptive name (up to 32 printable English keyboard characters) for
identification purposes.
Select an IP domain to which this VRRP entry applies.
Select a virtual router number (1 to 7) for which this VRRP entry is created.
You can configure up to seven virtual routers for one network.
MS-7206 User's Guide