Chapter 6 System Status and Port Statistics
6.1.1 Port Status
Use this screen to look at the status of each port in the selected slot. You can also clear the port
counters for each port in the slot. To open this screen, click Status in any web configurator
screen, and then click the number of the slot.
Figure 16 Port Status
The following table describes the labels in this screen.
Table 6 Port Status
LABEL
Port
Name
Link
State
PD
LACP
TxPkts
RxPkts
Errors
Tx KB/s
Rx KB/s
Up Time
Any
Port
Clear Counter Click this to clear the port counters for the specified port(s).
58
DESCRIPTION
This field displays the slot number and the port number. Click a port number to look at
detailed statistics for a specific port. See
This is the name assigned to this port. You can configure this in the Port Setup
screen. See
Chapter 12 on page
This field displays the speed (either 10M for 10 Mbps, 100M for 100 Mbps or 1000M
for 1000 Mbps) and the duplex (F for full duplex or H for half). It shows Down if there is
no connection. You can configure some of these settings in the Port Setup screen.
See
Chapter 12 on page
79.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the
port. If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it
displays STOP. See
Chapter 16 on page 95
This field displays the current amount of power consumed by devices (powered
devices, or PD) that use Power over Ethernet (PoE) to get power from the switch on
this port.
This fields displays whether LACP (Link Aggregation Control Protocol) is Enabled or
Disabled on the port. See
Chapter 20 on page 113
This field shows the number of frames transmitted on this port.
This field shows the number of frames received on this port.
This field shows the number of errors received on this port.
This field shows the number of kilobytes per second transmitted on this port.
This field shows the number of kilobytes per second received on this port.
This field shows the total amount of time in hours, minutes and seconds the port has
been up.
Select this, and click Clear Counter to reset all the port counters for this slot.
Select this, enter a specific port number, and click Clear Counter to reset the port
counters for the specified port.
Section 6.1.2 on page
79.
for more information about STP.
for more information about LACP.
59.
MS-7206 User's Guide