Remove A Management Card; Interface Modules; Add An Interface Module (System Is Off); Add An Interface Module (System Is On) - ZyXEL Communications MI-7248 User Manual

Chapter 3 Installing Cards
If there is another management card in the system, the new management card automatically
becomes the standby management card. If the firmware version of the new management card
is different than the firmware version of the existing management card, the new management
card does not function in the system.

3.1.3 Remove a Management Card

Remove the card from the MS-7206 chassis. If you remove the active management card, the
standby management card takes over.

3.2 Interface Modules

This section describes the steps required to add and remove interface modules. If you want to
hot-swap interface modules, follow the steps below to remove the existing interface module
and add the new interface module.
You can install interface modules in slot 3, slot 4, slot 5, or slot 6.

3.2.1 Add an Interface Module (System Is Off)

1 Insert the card in the MS-7206 chassis.
2 Turn on the system.
The system automatically detects what type of interface module is installed. You do not have
to configure the

3.2.2 Add an Interface Module (System Is On)

If the same type of interface module was previously installed in the slot, insert the card in the
MS-7206 chassis.
If a different type of interface module was previously installed in the slot or if no interface
module was previously installed in the slot, follow these steps.
1 Open the
(if necessary).
40
Slot Setup screen.
Slot Setup screen, and uninstall the existing type of interface module in the slot
MS-7206 User's Guide