Table of Contents
Advertisement
Chapter 13 VLAN
13.5 Static VLAN
Use a static VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depending on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
• blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the
specified VID.
13.6 VLAN Status
Use this screen to look at the current status of VLANs in the system. See
83
for background information about VLAN. To open this screen, click Advanced
Application > VLAN.
Figure 26 VLAN Status
The following table describes the labels in this screen.
Table 16 VLAN Status
LABEL
The Number of
VLAN
Index
VID
Elapsed Time
Status
Change Pages
86
DESCRIPTION
This is the number of VLANs configured on the switch.
This is the VLAN index number. Click on an index number to look at detailed port
settings for the VLAN.
This is the VLAN identification number that was configured in the Static VLAN
screen.
This field shows how long it has been since a normal VLAN was registered or a
static VLAN was set up.
This field shows how this VLAN was added to the switch.
Dynamic: The VLAN was added using GVRP.
Static: The VLAN was added as a permanent entry.
Other: The VLAN was added another way, such as Multicast VLAN Registration
(MVR).
Click Previous or Next to show the previous/next screen if all status information
cannot be seen in one screen.
Section 13.2 on page
MS-7206 User's Guide
Advertisement
Table of Contents
Troubleshooting
