Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 78 VRRP Status
LABEL
Index
Network
VRID
VR Status
Uplink Status
36.2.1 VRRP Configuration
Use this screen to specify the virtual routers in which the switch participates. Before
configuring VRRP, first create an IP interface (or routing domain) in the IP Setup screen. See
Section 10.2 on page 73
You can only configure VRRP on interfaces with unique VLAN IDs.
Routing domains with the same VLAN ID are not displayed in the table indicated. To open
this screen, click IP Application > VRRP > Configuration.
MS-7206 User's Guide
DESCRIPTION
This field displays the index number of a rule.
This field displays the IP address and the subnet mask bits of an IP routing domain
that is associated to a virtual router.
This field displays the ID number of the virtual router.
This field displays the status of the virtual router.
This field is Master indicating that this switch functions as the master router.
This field is Backup indicating that this switch functions as a backup router.
This field displays Init when this switch is initiating the VRRP protocol or when the
Uplink Status field displays Dead.
This field displays the status of the link between this switch and the uplink gateway.
This field is Alive indicating that the link between this switch and the uplink gateway is
up. Otherwise, this field is Dead.
This field displays Probe when this switch is check for the link state.
for more information.
Chapter 36 VRRP
207
Advertisement
Table of Contents
Troubleshooting
