Figure 1.6 Operation Panel (2.5" Type Controller Enclosure); Figure 1.7 Operation Panel (3.5" Type Controller Enclosure) - Fujitsu ETERNUS DX60 S2 User Manual

Chapter 1 Components
1.1 Controller Enclosure
●
2.5" type
POWER LED
READY LED
FAULT LED
IDENTIFY LED
CACHE LED
Power switch
Figure 1.6
●
3.5" type
POWER LED
READY LED
FAULT LED
IDENTIFY LED
CACHE LED
Power switch
Figure 1.7
●
Part explanation
• Power switch
This switch is used to turn on or off the ETERNUS DX Disk storage system.
• AUTO POWER switch
Enables the AC Auto-Link Mode (This function automatically turns on the linked device once
AC power is supplied).
The Auto Power function is disabled for the factory default setting.
• MODE SELECT switch
Enables the device power to be turned on via power linkage.
The MODE SELECT switch is enabled for the factory default setting. Do not change to OFF.
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
With a flange cover
Operation panel (2.5" type controller enclosure)
With a front cover
Operation panel (3.5" type controller enclosure)
14
Copyright 2013 FUJITSU LIMITED
Without a flange cover
AUTO POWER switch
MODE SELECT switch
IP RESET switch
Without a front cover
AUTO POWER switch
MODE SELECT switch
IP RESET switch
P3AM-5512-05ENZ0