Processing Error; Buffer Full Print - Star Micronics NP-226 Product Specifications

4.2 Processing error

1) Error detection details
Name
Comm. 232C Comm. error
error Parity
Overrun
Flaming
Data "?" print
Paper near Paper remain sense
empty CN7 sensor
Head up Head up
Paper end No paper
Head temp
Over 80°C
high
Cutter error Cutter jam
Eject sensor Paper at the exit
information sensor
When the above errors are detected except transmission error and paper low end error, printer
stops all operations and outputs error signal.
In the case of serial interface:
Error bit in the status information is set to "ON".
2) Return to normal status from error statuses
Remove causes of error statuses and turn the power on again to return to normal. When
this process is activated, at the time of power switch turned off, the printer will be initialized,
so that settings are required again.
If data remains in the buffer, attention should be paid

4.3 Buffer full print

If there remains data in the buffer after one line of data is received, printer automatically prints
preceding data. The volume of buffer full data varies depending on ASCII characters or bit
images.
D-F0390 NP-326 Product specifications Ver.0.02
Status BUSY
-
L
L
L
L
L
L
/ERR 232C
PE
OR status
- - -
H H 0bit 1
L L 1bit 1
H L 2bit 1
L L 3bit 1
H L 4bit 1
L H 6bit 1
17
PL
Removal
status
- Align comm.
condition
Load paper
-
Head up lever
On
down
On Load paper
Return normal
Flash
with 60°C
Remove jam and
Flash
Turn on again
Remove paper
-