Star Micronics NP-226 Product Specifications page 35

23) Printer status transmission
Code
Sends current printer status
* Status to be transmitted consist of 1 byte and the content is explained in the chart below.
bit
0
1
2
3
4
5
6
7
* Make sure that command is issued before transmission of print data.
(commands are stored in the input buffer and executed sequentially)
* Reception is available except in the buffer full status.
* The commands above are valid only for serial interface.
* Regarding DTR/DSR control, only one byte is transmitted after confirmation that the
host is able to receive data, that is DSR signal is in SPACE status. For XON/OFF
control, one byte is transmitted without confirmation of DSR signal status.
* For DTR/DSR control, if host is not in a receivable status, it waits until host can receive
data.
24) Inverted character set and reset
Code
Sets or resets the inverted character function
* "n2 is only valid for the LSB(b0)
* LSB (b0) has the following meaning
b0
0 resets inverted character
1 sets inverted character
* The command is only valid when it is assigned at the beginning of a line.
* The default value of n is [00] h.
25) 90° clockwise rotated character set and reset
Code
Sets and resets 90° clockwise rotated character.
* Underline cannot be assigned to the 90° clockwise rotated character.
* "n" has the following meaning.
n(hex)
00
01
* Default value for "n" is [00] h.
D-F0390 NP-326 Product specifications Ver.0.02
:<< ESC v >>
: [1B] h + [76] h
Functions
paper near empty
platen open
paper end
head temp. abnormal
cutter problem
Undefined
paper remove sensor
information
not defined
: [1B] h + [7B] h + n
Description
: [1B] h + [56] h + n
description
reset 90° rotated character
set 90° rotated character
Value
0
paper present
normal
paper present
normal
normal cutter problem
no paper
:<< ESC { n >>
* [00≤n≤FF] h
:<< ESC V n >>
* [00≤n≤01] h
31
1
near empty
head open
no paper
Temp. high
paper present