Printing Area And Cut Position - Star Micronics NP-226 Product Specifications

2.2 Printing area and cut position

Cut Position
Feed direction
Note2: Please take care not to take the paper very hard after the partial cut, which cause heavy load on
platen and might cause the poor print quality on the head part of next line. To avoid such problem,
please take care by feeding approx. 1 mm at the beginning of print or by take the paper to the direction
to left or right.
Note3: The cut mode (full cut or partial cut) is set by the factory. No change of cut mode is done by the
command setting.
A
NP-226 432
NP-326 576
D-F0390 NP-326 Product specifications Ver.0.02
1dot 2dots
0.125mm
B ±0.2mm
C ± 1.0mm
B C D
54 2 58
72 4 80
Partial cut remaining tab: aprox. 2 mm
A dots
4.0±1.0mm
0
D mm
-1
5
Cutter to Head
Approx.13±1.0mm
(Note1)
0.125mm
(Note2)
Approx. 3 mm feed will
took place by the
firmware, so the margin
will be 16±1mm.