Table of Contents
Advertisement
34) Download bit image print
Code
Description : Prints "download bit image" in a mode assigned by "m".
* Modes to be assigned by m are as follows.
m
00
Normal mode
01
Double width
02
Vertical double
03
Quadruple
* If there are some data left in the print buffer, this command is neglected.
* If "download bit image" is not defined yet, this command is neglected.
* "Download bit image" data exceeding 1 line cannot be printed.
35) Data input control
Code
Description:Selects valid device where data input is possible through host computer.
* Each bit of "n" has the following meaning.
Bit
0
Printer
1
Not defined
2
Not defined
3
Not defined
4
Not defined
5
Not defined
6
Not defined
7
Not defined
* If printer is not in "no selection" status, printer will discard all received data until it is in
the selection status by this command.
* Even if printer is in no selection status, the status may become BUSY by printer
operation.
* The default value of "n" is [01] h.
36) Print position alignment
Code
Description : Aligns all data to be printed on the assigned position in a line.
* "n" values are assigned to:
n (Hex)
00
01
02
* This command is valid only when it is input at the head of a line.
* The default value of "n" is [00] h.
37) Cut
Code
* Cut the paper.
* Effective at the head of a line
* Feeds paper by 3mm after paper cut to prevent from paper jam.
D-F0390 NP-326 Product specifications Ver.0.02
:<< GS / m >>
: [1D] h + [2F] h + m
Modes
Vertical
203 dpi
203 dpi
101 dpi
101 dpi
:<< ESC = n >>
: [1B] h + [3D] h + n
Function
0
Invalid
:<< ESC a n >>
: [1B] h + [61] h + n
Position
Left
Center
Right
:<< ESC i >>
: [1B] h + [69] h
* [00≤m≤03] h
Dot density
Horizontal
203 dpi
101 dpi
203 dpi
101 dpi
* [00≤n≤FF] h
Values
1
Valid
34
* [00≤n≤02] h
Advertisement
Table of Contents
