MedAllioN PlATe iNsTAllATioN
Ceiling Medallion
Bracket
Step 5. Raise the medallion plate to the ceiling medallion
bracket and fit the four keyholes into the adjuster (A) screws.
To align, insert an alignment tab onto each of the four
adjustment screws with the printed side facing up. Align the
raised dots with the alignment tabs. Twist the medallion plate
clockwise until locked into place. Pull out the four tabs.
Alignment
Tabs
raised
dots
Medallion Plate
BlAde PrePArATioN ANd iNsTAllATioN
BlAde hArdwAre (not to scale)
Blade irons (5)
Blade Medallions (5)
Blades (5)
screw Pack d
screw Pack e
Blade screws (21)
Blade iron screws (11)
Step 6a. Sandwich a blade between a blade medallion and
blade iron. Thread four blade screws (Pack D) through the
screwholes and tighten using the provided screwdriver. Repeat
Blade screws
for each blade.
Step 6b. Attach each blade/blade iron assembly to the motor
by threading two blade iron screws (Pack E) through the
matching holes in the blade iron and the motor. using the
Phillips screwdriver, tighten the screws loosely. After all
five blade assemblies have been installed, tighten the screws
securing with the screwdriver.
Blade iron screws
6