Motor Installation; Motor Housing Installation - Casablanca Silhouette II Owner's Manual

nOTE: You will need an assistant to help hold up the
ceiling medallion bracket and motor in steps 3 and 4.
Step 3a. Remove the paper shield from the motor.
Step 3b. Attach one of the hooks on the outside of the
motor onto one of the loops hanging from the ceiling
medallion bracket.
Step 3c. Attach the fan wires to the ceiling medallion
bracket wiring by placing the bare end of the wires side
by side and then securing with a wire nut (Pack C). Test
that the connection is secure by pulling on the wire nut.
Connect in this order:
• GREEn leads f rom ceiling medallion bracket
to GROund conductor of power source. Secure with
wire nut.
• WHITE wire from fan to white nEUTRAl wire in
ceiling medallion bracket. Secure with wire nut.
• BlACK power wire from fan to BlACK power wire in
ceiling medallion bracket. Secure with wire nut.
After making the wire connections, the wires should
be spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the outlet
box and the ungrounded conductor on the other side of
the outlet box.
nOTE: If the color of your ceiling wires differs from that
described, consult an electrician.
Step 3d. Trim excess motor wires to six inches and tuck
inside. The splices after being made should be turned
upward and pushed carefully into the outlet box.
Step 3e. Attach other two hooks.
Step 4. Align the three motor housing (B) screws into
the keyholes on the motor housing and twist until secure.
Tighten screws using the Phillips-head screwdriver.
nOTE: When aligning the screws, center the motor
housing so that there is an even amount of space all around
the motor.

MoTor iNsTAllATioN

MoTor housiNG iNsTAllATioN

S
ilhouette
Ceiling
Medallion
loops
1 Blue to 1 Black wire
ii
™
Motor
hooks
3 Green wires
2 white wires
5