Advan•Touch™ Control Installation - Casablanca BAROLO Owner's Manual

ADVAN•TOUCH™ CONTROL INSTALLATION
Step 1. Remove the two 6-32 x 5/
16" screws holding the bracket to
the holster. Save screws for later.
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with
an isolating wall control/switch. CAUTION! Do not use with wall dimmer.
Inner
mounting
holes
Control
Bracket
Standard Light Switch
Step A. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step C. Insert and tighten the screws using the provided
screwdriver.
Wall Installation
Step A. Locate a 2x4 wall
stud in a convenient
location.
Step B. Orient the control
bracket as shown over the
2x4 stud.
Step C. Insert the 1" wood
screws in either the inner
or outer mounting holes
and tighten using the
provided screwdriver.
Step 2
After you have completed installing the bracket to the wall, using the 2 screws removed in Step 1, attach the W-62 -holster
to the bracket.
12
W-62 BRACKET / HOLSTER REMOVAL
CONTROL BRACKET INSTALLATION
Standard
Toggle
Switch
Switch
Cover
Plate
ATTACH HOLSTER TO BRACKET
Holster
Outer
mounting
holes
Control
Bracket
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up
the two inner mounting holes with those on the switch.
Step D. Insert and tighten the screws using the provided
screwdriver.
NOTE: The wall anchors and 6-32 x 1" screws may be
used in situations where mounting to a stud is not possible.
Use the inner mounting holes. After securing the anchor,
discard the anchor's pointed screws and use the 6-32 decor
ovalhead screws supplied.
Anchor
Panhead
Screw
Wood
Screw 1"
Bracket
Rocker
Light
Switch
Switch
Cover
Plate
Drywall Anchor
Decor Ovalhead Screw
6-32 X 1"