Casablanca BAROLO Owner's Manual page 14

Pressing the 'SECURITY' button will start the Security lighting
program. The controller beeps and indicates 'SECURITY'. The
light will automatically turn ON and OFF in a seemingly random
manner over an eight and a quarter hour programmed cycle that
is designed to give the home a "lived-in" look.
Regardless of the light setting when switching to the Security
mode (lights on or off, dim or bright), the lights will increase to
high brightness and then begin the Security cycle. This cycle is
then repeated continuously until cancelled by pressing the
'SECURITY' button.
At any time during the Security mode you may adjust the fan
speed, reverse the direction, operate in Auto Speed or Winter,
use Saver or run the Test mode without affecting Security mode.
You may still turn the light ON and OFF (or OFF and ON)
manually for temporary lighting, but the light will continue to
operate automatically at its programmed times.
Note: All fans leave the factory set to "10000"
You will have to change the dip switch settings in the remote
if you are using more than one fan in the same area and want
to control them separately.
Step 1. At the circuit breaker or fusebox, turn the power off
for the fan you want to change.
Step 2. Open the battery door of the Advan•Touch control
and remove the first battery on the left to gain access to the
dip switches.
Step 3. Change the dip switch settings, assuring that they
are different from the previously installed Advan•Touch
fan(s).
Step 4. Re-install the battery in the proper polarity and the
battery door on the control.
Step 5. At the circuit breaker or fuse box, turn the power
back on for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the up
and down buttons at the same time. Hold for a few seconds.
You will see the LCD Screen flash all of the graphics. You
will now have control of the fan.
Note: You may want to label your controls to ensure you do
not mix them up.
If the fan is not functioning after installation:
Step 1. Check to make sure the batteries are installed properly in the control.
Step 2. Turn the power off to the fan (from the circuit breaker) for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push the up and down buttons at the same time, within 20
seconds from restoring power.
Step 4. The fan should now function properly.
14
SECURITY FEATURE
CHANGING FREQUENCY SETTING
IF THE FAN DOES NOT WORK
SECURITY MODE CYCLE
1. On for 60 minutes (80% bright)
2. Off for 30 minutes
3. On for 120 minutes (30% bright)
Dip Switch
Location
4. Off for 60 minutes
5. On for 90 minutes (50% bright)
6. Off for 60 minutes