Casablanca BAROLO Owner's Manual page 13

Open Battery Door by
pressing down on the
insert tab provided.
Battery
Door
Power turned off, interrupted or failure:
The remote control is battery operated, therefore if the power is turned off, interrupted or you experience a power failure, the
remote control remembers the previous setting for both fan and light.
Button operation:
Rapid button operation causes erratic fan operation.
For reliable operation of the remote control and fan you must wait one second between button presses to allow the radio
signal to be transmitted to the fan and received.
Fan Operation
The Advan•Touch fan is controlled by the remote control. The fan button located
in the center top row turns the fan on or off.
With the fan on, the control display will show an up or down moving arrow that
indicates direction and places a box around the operating speed. It will also show
you a moving fan image that tells you the fan is on and what direction the blades
are moving in (looking up from underneath the fan).
Just below the fan button, there are two
(on the left) to increase fan speed once for each press and the
right) to decrease speed once for each press.
Use the reverse button to change the direction of the rotation. Reverse operates at
any speed. The fan returns to its set speed after reversing.
You will see the airflow direction arrow change each time to press reverse.
Light Operation
The light is turned on or off independently of the fan by pressing the LIGHT
button. Keep pressing the button (hold it down) and it becomes a dimmer. The
light varies from "bright" to "dim" over approximately 8 seconds. This sequence
will reverse the light when it reaches the brightest or dimmest level if you continue
to hold the LIGHT button. Release the button when the desired level is reached.
Safe Exit Feature
To turn off the light, press the button once and the light will increase slightly if
less than 100% and gradually turn off, taking approximately 20 seconds. (If set at
100%, light will decrease to about 50% and then gradually turn off.) This enables
you to leave a room or your home safely before the lights go completely out.
Press the light button two times and the light will immediately dim to about half
and then turn off completely.
The fan will remember the last light setting and will come on at that setting until
charged.
Bulb Saver Feature
When the light is turned on, the brightness will take 1.5 seconds until it reaches
the present level. This feature helps extend light bulb life.
BATTERY INSTALLATION
IMPORTANT OPERATING NOTES
OPERATION
and buttons. Use the
B B B B B
Install 4 "AAA" alkaline
batteries in the space provided.
Please observe proper polarity
placement. Replace Battery
Door.
button
button (on the
™ ™ ™ ™ ™
AROL AR AR AR AR OLO O O O O OL OL OL
13